Analogue Solutions AS0084 Case NoiseBug Price : $220.00 Manufacturer Description: Introduction This is a lower cost alternative to the pricey aluminium style cases. The AS0084 will take any combination of Concussor, A100 or Integrator modules with no problems of gaps or lining up because it does not use tapped strips. Note: Integrator modules are a little wider than Concussor and A100, so it may not be possible to fill the case with only Integrator modules - the total width may be too wide by say 0.5mm. Power Supply The power supply board has 9 Doepfer style connectors and 3 Integrator sockets. A 5V power rail is provided for those modules that require it. Mounting The AS0084 case eliminates the use of tapped strips, used in the metal case. This saves a heck of a lot of money, but it does mean you must drill your own mounting holes. The modules are mounted with self tapping screws into plastic mounting blocks. As plastic is not as strong as metal, these cases are not ideal if you constantly are swapping modules around. Although this can be done many times, the thread in the plastic screw holes can weaken with time with constant screwing and un-screwing. All that is needed is to position modules in the case, mark the mounting holes, remove modules, drill pilot holes approx 1mm to 2mm diameter, screw modules into position. This is far easier than it sounds, but if it puts you off then pay the full cost for a metal case! (Nearly x2).