Analogue Solutions VCO-SUB Voltage Controller Oscillator with Sub Output
NoiseBug Price : $145.00
Related Items:
Analogue Solutions Modules are the same physical size and use the same power connectors as Doepfer a100 modules. They will mount in Doepfer eurorack cases and are 100% compatible when patching.
The red stripe on the power ribbon is red line down if used with Doepfer cases.
Included is a eurorack power ribbon and eurorack screws. Analogue Solutions screws available upon request.
Width 12HP
Manufacturer Description:
High-end VCO with Sub outputs
Width 12HP
Requires 5V
VCO is a single VCO laid out in a similar way to the VCO section you would find on a monosynth. VCO includes a glide (slew) function, so this is a great bonus. The VCO can go down to low frequencies so they can be used as an LFO.
Controls In Detail
Tune
The VCO has a wide ranging tune control. Turning Tune alters the basic pitch of the oscillator.
Glide
Turning up Glide adds portamento to the oscillator, so the pitch will bend (slide) up or down to each note (as opposed to a sudden change). The higher the setting, the longer the oscillator takes to reach its new note. Not many VCO modules give you the all important Glide control as standard!
Pulse Width
You can alter the pulse width (duty cycle) of the square wave. Turning this gives a sound similar to chorusing. In the centre position a square wave is produced.
Sawtooth Level
This sets the output volume of the sawtooth waveform output.
Square Level
This sets the output volume of the square waveform output.
Sockets in Detail
CV in
This socket is the pitch CV control input and is used to control the pitch of the oscillator.
PW
This is a pulse width control CV input. Use a -12 to +12V voltage in this socket to alter the pulse width of the oscillator square wave.
Sync In
This is an oscillator Sync reset input.
Sawtooth Out
This is the audio output for the sawtooth waveform. Its level is affected by the sawtooth level pot.
Square Out
This is the audio output for the square waveform. Its level is affected by the square level pot.
Sub 1 Out
This is a Sub-Osc output 1 octave below the main saw/square outputs.
Sub 2 Out
This is a Sub-Osc output 2 octaves below the main saw/square outputs.
Sub 3 Out
This is a Sub-Osc output 3 octaves below the main saw/square outputs.
